New setup for fretting fingerboard extension

Questions about tools and jigs you want to buy/build/modify.

New setup for fretting fingerboard extension

Postby Barry Daniels » Sat Apr 27, 2019 4:07 pm

This may be nothing new but I came up with a good method for fretting the fingerboard extension on a detached neck. I made a diy version of a Jaws II a couple of years ago and it works OK but is a bit of a balancing act. On a current repair I had to pull the neck of a red-label yamaha and am converting it to a bolt-on. I decided to refret the neck while it is off the body. The lower frets were easily installed with my arbor press. But the frets over the extension begged for a different approach.

I clamped the extension to the end of my workbench with Quick clamp and a slotted spacer block under the bench top to cover the hangar bolts sticking out of the heel. The jaws II worked really well in this setup as the neck is held firmly to the workbench. I can walk away with the clamp in place to allow the fret to setup.
Attachments
IMG_1428Resized.jpg
IMG_1429Resized.jpg
MIMF Staff
Barry Daniels
 
Posts: 2337
Joined: Thu Jan 05, 2012 10:58 am
Location: The Woodlands, Texas

Return to Tools and Jigs

Who is online

Users browsing this forum: No registered users and 2 guests

Your purchase from these sites helps support the MIMForum, but only if you start at the links below!!!
Amazon music     Amazon books     Amazon tools     Rockler tools     Office Depot    

The MIMF is a member-supported forum, please consider supporting us with a donation, thanks!
 • Book store • Tool store • Links •