body thickness

Please put your pickup/wiring discussions in the Electronics section; and put discussions about repair issues, including "disappearing" errors in new instruments, in the Repairs section.

body thickness

Postby Micah Covington » Tue Jun 26, 2012 8:26 am

So......

I glued up a body blank and surfaced it. After surfacing the body is quite a bit thinner than I had originally planned. It is currently about 1.25 inches thick. Is there any reason why this wont work? Assuming the neck will still fit, the only real negative I can think of is that a thinner body will affect the balance a bit.
Micah Covington
 
Posts: 36
Joined: Mon May 28, 2012 9:49 am

Re: body thickness

Postby Mark Swanson » Tue Jun 26, 2012 8:37 am

There's nothing that says it won't work, but the bottom line is your design. My rule for building is that if something is not right DO NOT go on until you get it right, otherwise the finished guitar will never be right and you'll always know it. My suggestion to you is to get a top for the blank. Glue it on and get back to the thickness you wanted. A fancy wood top can be really pretty.
    Mark Swanson, guitarist, MIMForum Staff
User avatar
Mark Swanson
 
Posts: 1969
Joined: Thu Jan 05, 2012 11:11 am
Location: Grand Rapids, Michigan USA

Re: body thickness

Postby Rodger Knox » Tue Jun 26, 2012 3:53 pm

Nothing wrong with 1.25" thickness, unless you have a pickup switch. It may still be OK, but you'd better check out all your electronics to be sure there's enough depth in the body to route the electronics cavity. +1 for adding a 1/4" top.
A man hears what he wants to hear, and disreguards the rest. Paul Simon
Rodger Knox
 
Posts: 497
Joined: Mon Jan 09, 2012 2:02 pm
Location: Baltimore, Maryland

Re: body thickness

Postby julian gifford » Sun Jul 01, 2012 12:23 pm

Also depends on the bridge you want to use. A tremolo bridge has the bridge block going through the body. They can be shaved down easy enough. I made a pair with strat tremolos at 1.33" thick (on purpose) For a TOM or any other style of bridge besides a tremolo, that thickness isnt an issue.

Agree with Robert. You need to be sure you have the depth for your elecronics to fit. This was a big concern on my thinner one's- A gibson style 90 degree 3 position toggle doesnt require much depth.

+2 put a fancy cap on it.
julian gifford
 
Posts: 41
Joined: Thu Mar 22, 2012 3:01 pm


Return to Solid-Body and Chambered or Semi-Solid Electric Guitars and Bass Guitars

Who is online

Users browsing this forum: No registered users and 2 guests

Your purchase from these sites helps support the MIMForum, but only if you start at the links below!!!
Amazon music     Amazon books     Amazon tools     Rockler tools     Office Depot    

The MIMF is a member-supported forum, please consider supporting us with a donation, thanks!
 • Book store • Tool store • Links •