nut and saddle material

Please put your pickup/wiring discussions in the Electronics section; and put discussions about repair issues, including "disappearing" errors in new instruments, in the Repairs section.
Post Reply
Micah Covington
Posts: 36
Joined: Mon May 28, 2012 9:49 am

nut and saddle material

Post by Micah Covington »

I know brass is used for bass nuts. Would aluminum be a good material? I am asking because I have some aluminum bar stock which is about the right size.

Rodger Knox
Posts: 497
Joined: Mon Jan 09, 2012 2:02 pm
Location: Baltimore, Maryland

Re: nut and saddle material

Post by Rodger Knox »

Aluminium was used by Vox in the mid 20th century in conjunction with a zero fret.
A man hears what he wants to hear, and disreguards the rest. Paul Simon

User avatar
Mark Swanson
Posts: 1971
Joined: Thu Jan 05, 2012 11:11 am
Location: Grand Rapids, Michigan USA
Contact:

Re: nut and saddle material

Post by Mark Swanson »

I have used aluminum, it works well. It buffs up real pretty too.
  • Mark Swanson, guitarist, MIMForum Staff

User avatar
Greg Robinson
Posts: 686
Joined: Fri Jan 06, 2012 1:54 pm
Location: Coburg North, Victoria, Australia

Re: nut and saddle material

Post by Greg Robinson »

Danelectro have used aluminium for nuts. It does tend to gall a bit and can cause the wound strings to stick a bit, but nothing too bad. It does look cool!
MIMForum staff member - Melbourne, Australia

Henrique Schneiter
Posts: 88
Joined: Sun Feb 05, 2012 12:59 am

Re: nut and saddle material

Post by Henrique Schneiter »

I have used for nuts and saddles. Besides what the guys mentioned above, you may remember those nuts are harder on the files, too.

Post Reply