Banjo saddle moving
-
- Posts: 78
- Joined: Sun Jan 08, 2012 4:59 pm
Banjo saddle moving
A friend of mine has a 6-str banjo where the saddle seems to be moving, constantly throwing the thing out of tune... is it common at all to glue the saddle to the resonator top, or is there another solution??
-
- Posts: 180
- Joined: Mon Dec 18, 2017 3:08 pm
Re: Banjo saddle moving
No, don't glue the saddle (bridge) to the top. It's meant to be held in place only by the pressure of the strings. If it's moving lengthwise (parallel to the strings), that means it's too loose. This could be caused by (1) the head needing to be tightened, (2) the neck angle needing to be reset, (3) the bridge being too low, or (4) some combination of the above. If it's moving sideways (perpendicular to the strings), that could be caused by the neck being at the wrong side-to-side angle (yaw). The latter problem is common to homemade 5-string banjos, because they have asymmetrical necks. Don't know about 6-strings.
-
- Posts: 78
- Joined: Sun Jan 08, 2012 4:59 pm
Re: Banjo saddle moving
The movement is lengthwise.. I have no experience with banjos - is there a way to tell if the "drum skin" is not tight enough , or how does one determine enough tension? ( - I was thinking about just fixing the bridge with a small strip of double sided tape... )
-
- Posts: 1674
- Joined: Fri Jan 06, 2012 12:04 pm
Re: Banjo saddle moving
Many banjo tail pieces have a way to adjust the down bearing (increase it). If the head is too loose it should appear to be depressed below the rim at the bridge.
-
- Posts: 1186
- Joined: Wed May 30, 2012 11:47 pm
- Location: Edmonton AB. Canada
Re: Banjo saddle moving
Banjo heads are designed to be able to "tune" the sound.
A tight fitting head will sound a bit brighter; a loose one warmer.
As John Clifford said, if the bridge is moving lengthwise along the strings, the head is most likely too loose.
There is a lot of good banjo setup information on Youtube.
A tight fitting head will sound a bit brighter; a loose one warmer.
As John Clifford said, if the bridge is moving lengthwise along the strings, the head is most likely too loose.
There is a lot of good banjo setup information on Youtube.
I need your help. I can't possibly make all the mistakes myself!
-
- Posts: 469
- Joined: Fri Feb 03, 2012 10:14 am
- Location: Central New Jersey
Re: Banjo saddle moving
Someone may have cleaned the head with some sort of furniture polish like Pledge. You might try cleaning the head and the feet on the bridge with naptha.
-
- Posts: 141
- Joined: Fri Jul 28, 2023 2:08 am
Re: Banjo saddle moving
I'll definitely check out some YouTube videos for more tips on banjo setup. Tightening the head for a brighter sound and loosening it for a warmer tone makes sense.Gordon Bellerose wrote: ↑Mon Jun 25, 2018 1:13 pm Banjo heads are designed to be able to "tune" the sound.
A tight fitting head will sound a bit brighter; a loose one warmer.
As John Clifford said, if the bridge is moving lengthwise along the strings, the head is most likely too loose.
There is a lot of good banjo setup information on Youtube.