removing headstock fiberboard overlay

If you have a string instrument of any kind that needs fixing, a mistake you made in building a new instrument that you need to "disappear," or a question about the ethics of altering an older instrument, ask here. Please note that it will be much easier for us to help you decide on the best repair method if you post some pictures of the problem.
Post Reply
James Gates
Posts: 17
Joined: Fri Jan 20, 2012 3:52 pm

removing headstock fiberboard overlay

Post by James Gates »

The headstock fiberboard overlay is warped and the logo is mostly worn off.
I can get a putty knife under part of it.
What is a good way to remove the overlay?
I am not interested in repairing it a I will be replacing it.

Nick Middleton
Posts: 91
Joined: Fri Jan 06, 2012 11:49 am

Re: removing headstock fiberboard overlay

Post by Nick Middleton »

If you have no intention of saving the overlay:

Set up 2 guide-rails that run in the same plane as the headstock.
Then use a router to shave it off in a few passes.

This is technique that also works for removing fingerboards.

User avatar
Mark Swanson
Posts: 1971
Joined: Thu Jan 05, 2012 11:11 am
Location: Grand Rapids, Michigan USA
Contact:

Re: removing headstock fiberboard overlay

Post by Mark Swanson »

I'd just heat it up and remove it with a flat knife or scraper. A heat gun will work, and even a clothes iron will work, just be careful and get it no hotter than you need to- keep checking. If you want to save the finish on the other surfaces of the peghead then heat will damage it quickly so be careful.
  • Mark Swanson, guitarist, MIMForum Staff

Post Reply