radius dish

Please put your pickup/wiring discussions in the Electronics section; and put discussions about repair issues, including fixing errors in new instruments, in the Repairs section.

radius dish

Postby Elmin Basovic » Fri Nov 03, 2017 3:33 pm

do i need a radius dish when I'm making a guitar?
Elmin Basovic
Posts: 16
Joined: Fri Nov 03, 2017 5:32 am

Re: radius dish

Postby Freeman Keller » Fri Nov 03, 2017 10:19 pm

It is helpful but not necessary. For my first couple I made some radiused cauls that I used to clamp braces against


You can stick sandpaper to the cauls later to sand the kirfing to the correct angle.

Another trick with a go-bar is to take a stack of buisness cards and fan them out on the bottom plate of the deck - take your curved brace and make the fan fit the brace. Then clamp against the cards
Freeman Keller
Posts: 339
Joined: Mon Feb 27, 2012 11:34 am

Return to Flat-Top Acoustic Guitars and Bass Guitars

Who is online

Users browsing this forum: No registered users and 6 guests

Your purchase from these sites helps support the MIMForum, but only if you start at the links below!!!
Amazon music     Amazon books     Amazon tools     Rockler tools     Office Depot    

The MIMF is a member-supported forum, please consider supporting us with a donation, thanks!
 • Book store • Tool store • Links •