A neck shaping jig

Questions about tools and jigs you want to buy/build/modify.
Post Reply
Paul Montgomery
Posts: 27
Joined: Fri Mar 23, 2018 9:09 pm

A neck shaping jig

Post by Paul Montgomery »

Clamping neck blanks for shaping is tricky but I just found a simple way. I'd be interested to know how you all accomplish that. Here is what I just figured out:

https://youtu.be/5J68M1_ByTA

Clay Schaeffer
Posts: 1433
Joined: Fri Jan 06, 2012 12:04 pm

Re: A neck shaping jig

Post by Clay Schaeffer »

nr4.jpg
Hi Paul,
I use a simple "L" type jig to rough shape necks with a router. I also use it for a router table fence (I made a cut out in it) and it can also be used as a drill press fixture. The neck blank is held on by two screws through the jig and into the fretboard side of the blank.

User avatar
Steve Sawyer
Posts: 917
Joined: Wed Jan 02, 2013 2:20 pm
Location: Detroit, Michigan

Re: A neck shaping jig

Post by Steve Sawyer »

Nothing revolutionary here, but I do find assorted pieces of 8020 extrusion to be very handy. This is how I use one for carving necks. Note the pads of leather between the FB and the beam to protect the FB, and the leather pads under the clamps. I should make a mounting "L" like Pauls to fit onto this beam!
Neck Holding.JPG
==Steve==

Bob Gleason
Posts: 17
Joined: Fri Jun 01, 2012 1:45 pm

Re: A neck shaping jig

Post by Bob Gleason »

IMG_0632.jpeg
This is really interesting to see how similar Steve's jig is to mine. Almost like we built then together. Mine has a T-Track in the center to adjust the hold downs.

User avatar
Barry Daniels
Posts: 2543
Joined: Thu Jan 05, 2012 10:58 am
Location: The Woodlands, Texas

Re: A neck shaping jig

Post by Barry Daniels »

I like both of them.
MIMF Staff

Post Reply