Fitting t bridge to new cones

Please put your pickup/wiring discussions in the Electronics section; and put discussions about repair issues, including fixing errors in new instruments, in the Repairs section.
Post Reply
Michael Cotterill
Posts: 1
Joined: Sat Jul 07, 2018 3:14 am

Fitting t bridge to new cones

Post by Michael Cotterill »

Hi Guys and Gals
I am building a weissenborn tricone hybrid and my first stumbling block is how the T bridge should sit on the cones. The Cones are new nationals, while the bridge is the cheaper non genuine. The pins on the bridge are bigger than the holes in the cones. Is this normal? Do i need to drill or reek out the holes in the cones to the size of the pin?

Appreciate any help.


Michael “Hossdog” Cotterill

Post Reply