Please put your pickup/wiring discussions in the Electronics section; and put discussions about repair issues, including "disappearing" errors in new instruments, in the Repairs section.
- Posts: 36
- Joined: Mon May 28, 2012 9:49 am
I know brass is used for bass nuts. Would aluminum be a good material? I am asking because I have some aluminum bar stock which is about the right size.
- Posts: 497
- Joined: Mon Jan 09, 2012 2:02 pm
- Location: Baltimore, Maryland
Aluminium was used by Vox in the mid 20th century in conjunction with a zero fret.
A man hears what he wants to hear, and disreguards the rest. Paul Simon
- Posts: 1972
- Joined: Thu Jan 05, 2012 11:11 am
- Location: Grand Rapids, Michigan USA
I have used aluminum, it works well. It buffs up real pretty too.
- Mark Swanson, guitarist, MIMForum Staff
- Posts: 686
- Joined: Fri Jan 06, 2012 1:54 pm
- Location: Coburg North, Victoria, Australia
Danelectro have used aluminium for nuts. It does tend to gall a bit and can cause the wound strings to stick a bit, but nothing too bad. It does look cool!
MIMForum staff member - Melbourne, Australia
- Posts: 91
- Joined: Sun Feb 05, 2012 12:59 am
I have used for nuts and saddles. Besides what the guys mentioned above, you may remember those nuts are harder on the files, too.