cupping wood - Back and top

Ask your wood and other materials questions here. Please DO NOT post pictures and ask us to identify your wood, we have found that accurate ID is nearly impossible, and such discussions will be deleted. Thanks.
Post Reply
Cory Weinberg
Posts: 1
Joined: Tue May 24, 2016 7:09 pm

cupping wood - Back and top

Post by Cory Weinberg »

I have a resawn top (Sitka Spruce) and back (Sapele) for my newest build. The wood has cupped. I wet the concave sections and pressed them for 5 days and although slightly reduced, they still present a signifcant challenge. I don't know what else to do to bring them back to flat. Any thoughts?
Chuck Tweedy
Posts: 1182
Joined: Fri Jan 06, 2012 6:25 pm
Location: San Diego, CA

Re: cupping wood - Back and top

Post by Chuck Tweedy »

How "deep" is the cup??
Are the plates to final thickness??

In general, if the cupping of a rough set is slight (~ 1/8" or 4mm), then after you thickness the plates 1 of 2 things will happen.
1) The cupping will go away
2) There will be such subtle cupping, that you can just ignore it

Acoustic guitar plates are so thin that the braces will determine the final shape.
The problem comes when you can not uniformly thin the plates - in a sander, or with a plane.
If they will not flex back enough to be processed, then you are SOL
Likes to drink Rosewood Juice
Clay Schaeffer
Posts: 1674
Joined: Fri Jan 06, 2012 12:04 pm

Re: cupping wood - Back and top

Post by Clay Schaeffer »

If you have a bending blanket you could try clamping them between two flat pieces of wood and heating them much as you would bend sides.
Daryl Kosinski
Posts: 121
Joined: Sat Oct 12, 2013 11:14 am
Location: Fultonville, NY

Re: cupping wood - Back and top

Post by Daryl Kosinski »

Your wood could be case hardened from improper drying. There is no cure for case hardened wood.
User avatar
Barry Black
Posts: 53
Joined: Mon Jul 01, 2013 9:51 pm
Location: Comox BC Canada

Re: cupping wood - Back and top

Post by Barry Black »

Sometimes I have found that even quarter sawn wood will cup after resawing simply because the interior moisture level is different from the outside. To correct, I simply lay them on the cement floor of my shop, concave down , with some weight to hold them in place for a few days. This has never failed for me. When thicknessing, always take material off of each side to maintain the stability.
Barry
Post Reply

Return to “Wood and Materials Q&A”