soundboard crack repair

If you have a string instrument of any kind that needs fixing, a mistake you made in building a new instrument that you need to "disappear," or a question about the ethics of altering an older instrument, ask here. Please note that it will be much easier for us to help you decide on the best repair method if you post some pictures of the problem.

soundboard crack repair

Postby Erik Savage » Tue Mar 01, 2016 2:42 pm

I recently picked up this guitar that is quite a bit nicer than what I normally get to work on.
IMG_0614_zpscaupa0ly.jpg


I'm pretty sure I can do a creditable job repairing the back/side,
IMG_0632_zpsc4kksdy6.jpg


but I'm a little nervous about repairing the soundboard crack unobtrusively, not having done this before.
IMG_0611_zpshfz53lkn.jpg


It's has been sitting in the basement humidifying for a month, but the crack doesn't seem to be getting any smaller.
I imagine it will be necessary to fit a sliver of wood into this crack. My plan right now is to get a couple of cheap soundboard blanks
and practice a bit first. It may be a while until I get to it. Would it make sense to glue a couple of cleats on the underside of the crack
to stabilize it until I fill the crack? Any advice would be appreciated. Thanks.
Erik Savage
 
Posts: 3
Joined: Mon Apr 20, 2015 5:02 pm

Re: soundboard crack repair

Postby Mark Swanson » Wed Mar 02, 2016 10:00 am

That crack doesn't look so bad to me. Does light shine through it? If not, I would just humidify it a bit more, and then clean it out, glue it and cleat it inside.
    Mark Swanson, guitarist, MIMForum Staff
User avatar
Mark Swanson
 
Posts: 1967
Joined: Thu Jan 05, 2012 11:11 am
Location: Grand Rapids, Michigan USA

Re: soundboard crack repair

Postby Erik Savage » Wed Mar 02, 2016 8:14 pm

The crack is a bit over 1/16" wide at the bridge, narrowing down toward the bottom. Getting it to close on it's
own would be best, so I'll leave it for a while longer then see. I'm probably just worrying overmuch. The
repair itself isn't that difficult, but if it really stands out it's going to bug me every time I pick up the guitar.
I am in no way a professional at this sort of thing, but I try to make repairs that I do as unobtrusive or as attractive as I can.
Thanks.
Erik Savage
 
Posts: 3
Joined: Mon Apr 20, 2015 5:02 pm

Re: soundboard crack repair

Postby Michael Lewis » Mon Mar 07, 2016 2:37 am

A crack along the grain like this is usually not a structural issue, but more of a cosmetic issue. It really shouldn't hurt the use of the instrument as it is, and just remember that it is much easier to make it all look worse than to make it better. If the crack will not close with re-humidifying then I would likely leave it as it is. If it causes rattles and buzzes then it should be glued and cleated (hot hide glue).

Installing and finishing a splint is a daunting task. It is simple enough to comprehend but is very difficult to install and blend it with the original wood and finish. Sometimes it works, but it is a tedious task to make it look good.
Michael Lewis
 
Posts: 1446
Joined: Thu Jan 12, 2012 1:22 am
Location: Northern California USA

Re: soundboard crack repair

Postby Ryan Mazzocco » Mon Mar 07, 2016 8:27 pm

Michael Lewis wrote:A crack along the grain like this is usually not a structural issue, but more of a cosmetic issue. It really shouldn't hurt the use of the instrument as it is


:o That's a new thought to me. I figured just about any crack was a ticking timebomb and needed immediate attention. I have a guitar that has cracked exactly as the one pictured in the OP and I've been trying to make time to get around to taking care of it. I guess I can relax a bit.
User avatar
Ryan Mazzocco
 
Posts: 560
Joined: Sat Feb 04, 2012 6:01 pm
Location: Joplin, MO

Re: soundboard crack repair

Postby Michael Lewis » Sat Mar 19, 2016 2:44 am

Usually a crack can be closed with putting humidity into the box, but sometimes the wood has undergone some change and the crack will not stay closed. I just happen to have two guitars in my shop with this issue. Both were exposed to extreme dryness and or heat. Once the cracks were nicely closed and glued I let them hang in my shop with RH 40%, and within a week they opened again.

I have had guitars from Reno NV (very dry and hot in the summer) with tops sunken from the excessive loss of moisture content. If you stretch a thread across the top just in front of the bridge (on Martin guitars) the thread should just touch all across from edge to edge. When a guitar is very dry there will be a gap between the thread and the top, sometimes as much as 1/8" (3 or 4mm) or more. The guitars can be re hydrated and this helps but often they will not come all the way back to where the thread will contact the top by the bridge.
Michael Lewis
 
Posts: 1446
Joined: Thu Jan 12, 2012 1:22 am
Location: Northern California USA


Return to String Instrument Repair: Practical and Political Issues

Who is online

Users browsing this forum: Google [Bot] and 1 guest

Your purchase from these sites helps support the MIMForum, but only if you start at the links below!!!
Amazon music     Amazon books     Amazon tools     Rockler tools     Office Depot    

The MIMF is a member-supported forum, please consider supporting us with a donation, thanks!
 • Book store • Tool store • Links •