MIMF

I have been in the shop playing with different ideas on making fretboard inlay dots, both materials and tools.

Here's a short video I made, although I'm sure that this group has some great ideas as well to share.

https://youtu.be/WfGWtFhsUKA

I like watching other people explore simple ideas almost as much as I like doing it myself. Thanks!

I recently tried this with plug cutters and found if I used the slowest speed on the drill press it worked best. Might not melt the plastic. I was using 1/8" veneer.

Having started this, there are some other ideas I'd like to explore but, alas. I could also clean my messy shop. Hmmm...

Thanks all.

Nice video !
For small dots I've used fuller countersinks with the drill bit retracted - kind of like a mini plug cutter. Some people have mentioned gluing the inlay material to the end of a drill bit and sanding it flush to make it round.
Always nice to have more than one way to skin a cat.

I don't think I would try any of that with shell. Got me thinking about turning wooden ones on the lathe and slicing them off. Use some nice figured wood.

Thanks for the video, Paul - food for thought.

I chuck a piece of wood about 3/8" square by 6 or 8" long into my hand held drill and hold it against a disc sander, both turning, making a 1/4" diameter rod (or about 3/32" for side dots). I make it for a tight fit into the dot holes, glue it in, then cut it off just proud of the fretboard, and move to the next hole. But I pretty much don't put dots in the top any more, just the side, (unless it's a lap held guitar), since a player can't see the top ones while playing. I've also used contrasting color plastic wood to fill the holes, then sand them down (I think Fender did this at some point.)