If you have a string instrument of any kind that needs fixing, a mistake you made in building a new instrument that you need to "disappear," or a question about the ethics of altering an older instrument, ask here. Please note that it will be much easier for us to help you decide on the best repair method if you post some pictures of the problem.
3 posts • Page 1 of 1
I'm trying to pull the neck on a 1972 Takamine ESN10C. Putting on a new top. I've done many neck resets, but this is the first time for a Takamine. According to the Library it has a dovetail joint. I pulled the 15th fret and drilled holes, but I'm having trouble finding the gap. I've angled the bit towards the soundhole and the peghead, but no luck so far. Does anybody have any advice?
Actually it's a 2010. After more research I found that Takamines are a bear to take apart, epoxied joint. So I cut the fingerboard at the 14th and removed the extension. Here's what I found. An epoxied dovetail with two aluminum rods extending into the neck block. I'm thinking now about cutting the neck off, making a new one, and converting to bolt on. I ran into a similar situation once with a Yari.
- Posts: 1470
- Joined: Thu Jan 12, 2012 1:22 am
- Location: Northern California USA
Dave, it's just another challenge to overcome. How about CAREFULLY cutting the neck off and converting to bolt on? It would require a very narrow kerf so very little heel is lost, and a new fingerboard moved slightly toward the nut to compensate for what gets lost at the heel. Good luck!