fixing a fretboard?

If you have a string instrument of any kind that needs fixing, a mistake you made in building a new instrument that you need to "disappear," or a question about the ethics of altering an older instrument, ask here. Please note that it will be much easier for us to help you decide on the best repair method if you post some pictures of the problem.

fixing a fretboard?

Postby Simon Magennis » Sat Sep 08, 2012 5:47 am

So far when I have had to re-saw a fret slot I have filled the old one with sawdust and ca glue. What are the alternatives? Does hhg work ok for this? Better? CA has the advantage that it is quick which is good but I hate the smell of the solvent. I have two fretboards where some of my higher (14th up) slots are off and I will first try to fix them rather than replacing the boards. Good repair practice. :D
Simon Magennis
 
Posts: 425
Joined: Sat Jan 07, 2012 7:51 am
Location: Würzburg. Germany.

Re: fixing a fretboard?

Postby Greg Robinson » Sun Sep 09, 2012 8:50 am

You could glue in slivers of veneer with a gap filling glue like CA (cyanoacrylate/superglue) or epoxy, or just fill with epoxy or epoxy with a filler material (microbeads, sawdust, etc.).
MIMForum staff member - Melbourne, Australia
User avatar
Greg Robinson
 
Posts: 686
Joined: Fri Jan 06, 2012 1:54 pm
Location: Coburg North, Victoria, Australia

Re: fixing a fretboard?

Postby Clay Schaeffer » Sun Sep 09, 2012 9:26 am

Cutting the filler strip so the grain is oriented the same as the board will help it be less noticeable. If the board is thick enough you could plane off the old fret slots and cut new ones. Sometimes a slightly mis-cut slot can be hidden by the fret and is less of a problem.
Another way to reuse flat fingerboards without showing the mistakes is to fill all the slots , recut them on the other side and bind the finished board.
Unless you can make the repair nearly invisible you may be better off sucking it up and using a new board with properly cut slots.
Clay Schaeffer
 
Posts: 1339
Joined: Fri Jan 06, 2012 12:04 pm

Re: fixing a fretboard?

Postby Chuck Tweedy » Mon Sep 10, 2012 8:21 pm

Ok, here a come a couple if's...

If the mistake slot will be covered by the fret and ...
if the board is ebony...

Then you can just size a stick of ebony to fit in the slot and glue it in with gap-filling CA. Then re-cut the slot in the right place. The repair will be be totally invisible. (DAMHIKT)
Likes to drink Rosewood Juice
Chuck Tweedy
 
Posts: 1111
Joined: Fri Jan 06, 2012 6:25 pm
Location: San Diego, CA


Return to String Instrument Repair: Practical and Political Issues

Who is online

Users browsing this forum: No registered users and 1 guest

Your purchase from these sites helps support the MIMForum, but only if you start at the links below!!!
Amazon music     Amazon books     Amazon tools     Rockler tools     Office Depot    

The MIMF is a member-supported forum, please consider supporting us with a donation, thanks!
 • Book store • Tool store • Links •