MIMF

HI.

I'm going to do 5 ply binding - is it feasible to glue the 5 strips together first and then glue them on? Or is it better to apply (say) 2 strips then 2 strips then the thicker outer strip?

I did a three ply all in one but would like to know if 5 at once is a step too far.

Thanks,
Rob.

I bought that StewMac thingie that is supposed to laminate binding, didn't like it. However I do do bindings (usually wood) with multiple purfling lines - I bend the binding first, route the channels and fit all the pieces in dry. Tape everything in place leaving gaps in the tape - wick a tiny drop of thin CA in between the tape pieces, pull the tape and run a very thin line of thin CA around all of the binding and purfling. Don't have a great picture to show but his is coco binding with four purfling lines - could have been more.
Sorry, when I look at the picture its pretty hard to see, but trust me there are five plies there

Thanks.