String break angle over the nut not sufficient?

Please put your pickup/wiring discussions in the Electronics section; and put discussions about repair issues, including "disappearing" errors in new instruments, in the Repairs section.

Re: String break angle over the nut not sufficient?

Postby Gordon Bellerose » Wed Oct 24, 2012 8:45 pm

Not knowing what guage of strings you are using, or how the nut has been cut, I am simply going from experience.

YES. You can use your nut files to file the slots on the bridge saddles. Actually, with a T.O.M. bridge that is how you set each string at the proper height.
The nut is still the most likely suspect in this scenario. If you have cut one of the slots at the same diameter as the string, you could be "choking" the string. What that means is that as the string vibrates it hits the side of the nut slot. If the nut slots are too deep, the same applies.
It could be also that the nut slot has a bit of a "slope". What I mean by that is the fingerboard edge could be a tiny bit lower than the headstock side, causing the string to vibrate against the lower portion.
Hope I've been helpful and not confusing.
I need your help. I can't possibly make all the mistakes myself!
Gordon Bellerose
 
Posts: 1160
Joined: Wed May 30, 2012 11:47 pm
Location: Edmonton AB. Canada

Previous

Return to Solid-Body and Chambered or Semi-Solid Electric Guitars and Bass Guitars

Who is online

Users browsing this forum: No registered users and 3 guests

Your purchase from these sites helps support the MIMForum, but only if you start at the links below!!!
Amazon music     Amazon books     Amazon tools     Rockler tools     Office Depot    

The MIMF is a member-supported forum, please consider supporting us with a donation, thanks!
 • Book store • Tool store • Links •