Please put your pickup/wiring discussions in the Electronics section; and put discussions about repair issues, including fixing errors in new instruments, in the Repairs section.
5 posts • Page 1 of 1
Hello Gilbert. Here's a quick diagrammatic sketch using an old neck side view I had drawn up long ago laid over a 24" x 4" block - perhaps you can compare the neck blank dimensions shown to what you're planning to use to get a feel for if two of yours can fit. PLEASE NOTE that the neck profiles drawn are not necessarily representative of the dimensions of your 24.75" scale L-O necks. You'll need to confirm dimensions and configurations.
I routinely get two necks out of the 24 x 4 x 3 blanks. Unlike the drawing above I plane the surface of the blank and then layout the neck from there although I expect the drawing was just to show that two necks would fit. If the wood does not have significant defects then it should be no problem.