Fitting t bridge to new cones

Please put your pickup/wiring discussions in the Electronics section; and put discussions about repair issues, including fixing errors in new instruments, in the Repairs section.

Fitting t bridge to new cones

Postby Michael Cotterill » Thu Aug 09, 2018 6:51 pm

Hi Guys and Gals
I am building a weissenborn tricone hybrid and my first stumbling block is how the T bridge should sit on the cones. The Cones are new nationals, while the bridge is the cheaper non genuine. The pins on the bridge are bigger than the holes in the cones. Is this normal? Do i need to drill or reek out the holes in the cones to the size of the pin?

Appreciate any help.


Michael “Hossdog” Cotterill
Michael Cotterill
Posts: 1
Joined: Sat Jul 07, 2018 3:14 am

Return to Flat-Top Acoustic Guitars and Bass Guitars

Who is online

Users browsing this forum: No registered users and 1 guest

Your purchase from these sites helps support the MIMForum, but only if you start at the links below!!!
Amazon music     Amazon books     Amazon tools     Rockler tools     Office Depot    

The MIMF is a member-supported forum, please consider supporting us with a donation, thanks!
 • Book store • Tool store • Links •