Page 1 of 1


Posted: Sat Mar 16, 2013 10:23 pm
by Chris Tremble
Iv just radiussed the fingerboard on my first build but realised i probably should have inlayed it first.

Should I start the fingerboard again or is there a way to inlay into a radiussded board?

Chris Tremble

Re: Inlays

Posted: Sun Mar 17, 2013 7:13 am
by Clay Schaeffer
Hi Chris,
I think many of us feel it is preferable to radius the fret board before doing inlays. You are less likely to sand through the inlay material doing it this way, and some thin semi-flexible materials can be made to conform to the radius.

Re: Inlays

Posted: Mon Mar 18, 2013 4:51 pm
by Steve Rolig
Agreed, I always radius the fret board first.