Mesh Bench Liner

TEST ON SCRAP FIRST! If your question is about repair work, either regluing or refinishing, please post it in our Repair Section.

Mesh Bench Liner

Postby Andrew McSpadden » Thu Dec 07, 2017 1:57 pm

This may not be the right section of the forum but here it is. I am looking for a source in the US for the soft rubber mesh that lines the benches of many shops that I have worked in and seen, They have it everywhere at PRS and I got it for CFox guitars from a restaurant supply company but that closed down.

It is sold as a shelf liner for restaurants to line their shelves for drying glassware. It is a open paper mesh dipped in soft rubber. It is GREAT for benches because the holes are big enough to let debris fall through and soft enough to not scratch finishes. There are many hard plastic versions of the same stuff but they will scratch and guitars slide right over them.

Thanks for your time!
Attachments
SandingBlog(H)-6915.jpg
Andrew McSpadden
 
Posts: 21
Joined: Wed Jan 02, 2013 4:28 pm

Re: Mesh Bench Liner

Postby Barry Daniels » Thu Dec 07, 2017 2:16 pm

You need to be careful with that kind of pad. Some have been reported to contain a lot of silicone which will contaminate your wood surfaces and mess up application of finishes in a bad way.

They are often sold by suppliers of routing accessories. Here is one:

http://www.rockler.com/non-slip-router-mat?source=googleps&gclid=CjwKCAiA6qPRBRAkEiwAGw4SdoQFRknmUsZShM_58HlCDbbQJF6T6ZjGMSk0UwTEf4ZCDtYoTBmonhoCB3UQAvD_BwE
MIMF Staff
Barry Daniels
 
Posts: 1754
Joined: Thu Jan 05, 2012 10:58 am
Location: Houston, Texas

Re: Mesh Bench Liner

Postby Charlie Schultz » Thu Dec 07, 2017 2:18 pm

User avatar
Charlie Schultz
Site Admin
 
Posts: 1245
Joined: Fri Dec 23, 2011 6:53 pm
Location: Atlanta, GA

Re: Mesh Bench Liner

Postby Bryan Bear » Thu Dec 07, 2017 4:06 pm

I was about to caution you of the same thing Barry mentioned. I had some issues with shelf liners leaving a residue that interfered with finish. I don't think it was silicone in my case because I was able to fairly easily sand it away and start over, it wasn't as tenacious of a problem as I would expect from silicone. Even if you find something that is supposed to be silicone free, test it out on some scrap before putting all over your shop.
PMoMC

Take care of your feet and your feet will take care of you.
User avatar
Bryan Bear
 
Posts: 939
Joined: Fri Jan 06, 2012 1:05 pm
Location: St. Louis, MO

Re: Mesh Bench Liner

Postby Andrew McSpadden » Thu Dec 07, 2017 6:41 pm

I am looking to use it less as a non slip mat and more for the large holes that let debris fall through. Great for setup and sanding benches.

I did find some at a yard sale years ago that did have silicone! Got rid of it fast. There must be a supplier that carries this because I see it in every mid to large size guitar factory.
Andrew McSpadden
 
Posts: 21
Joined: Wed Jan 02, 2013 4:28 pm

Re: Mesh Bench Liner

Postby Keith Howell » Sun Dec 10, 2017 8:00 am

Keith Howell
 
Posts: 30
Joined: Sat Apr 07, 2012 3:54 am
Location: Cape Town South Africa

Re: Mesh Bench Liner

Postby Darrel Friesen » Tue Dec 12, 2017 12:03 pm

Darrel Friesen
 
Posts: 188
Joined: Fri Jan 06, 2012 5:48 pm


Return to Glues and Finishes

Who is online

Users browsing this forum: No registered users and 1 guest

Your purchase from these sites helps support the MIMForum, but only if you start at the links below!!!
Amazon music     Amazon books     Amazon tools     Rockler tools     Office Depot    

The MIMF is a member-supported forum, please consider supporting us with a donation, thanks!
 • Book store • Tool store • Links •