Help! Magnet swap gone awry on a DiMarzio humbucker

Pickups, magnets, microphones, amps, speakers, cabs, whatever...

Help! Magnet swap gone awry on a DiMarzio humbucker

Postby Dave Locher » Wed Dec 23, 2015 6:36 pm

So I watched a few videos on YouTube, and decided to put an alnico 5 magnet into my DiMarzio super distortion humbucker pick up. I am hoping for less harshness and to make it sound more like my 1978 Ibanez V-2 pickup, which was a copy of the Dimarzio only with Alnico 5 magnets rather than ceramic.

Anyway, I opened up the pickup and immediately ran into two problems. The ceramic magnet is narrower than the A5, which means the A5 will not fit between the poles. Problem number two is that the ceramic magnet is also two or three times as thick as the A5, which means even if I could put it in there between the lugs, when I try to tighten down the base plate it's going to bottom out on the pole pieces long before the magnet hits the bottom of the coils.
Can this swap be done? Or should I just buy another pickup and forget it?
Could I stack the Alnico magnet between the ceramic and the base plate? If so, would it actually change the tone much?

I thought I was being really clever but I very quickly fell in over my head!
Dave Locher
 
Posts: 155
Joined: Thu Feb 02, 2012 2:56 pm

Re: Help! Magnet swap gone awry on a dimarzio humbucker

Postby Jason Rodgers » Thu Dec 24, 2015 1:59 am

What are the dimensions of the ceramic? To avoid mucking around too much and screwing something up, try to find an AlNiCo with dimensions as close as possible on mojotone, allparts, guitarpartsusa, or philadelphialuthiertools.
-Ruining perfectly good wood, one day at a time.
Jason Rodgers
 
Posts: 1553
Joined: Fri Jan 06, 2012 4:05 pm
Location: Portland, OR

Re: Help! Magnet swap gone awry on a DiMarzio humbucker

Postby David King » Mon Dec 28, 2015 2:27 am

You can take two Alnico bars and stack them in parallel N-N and S-S. To reduce the width you can grind them down with a N or P-100 dust mask on a coarse grinding wheel. Cobalt is considered a dangerous material to breath in. It's very time consuming to grind as the material is very hard.
David King
 
Posts: 2431
Joined: Sat Jan 07, 2012 10:01 pm
Location: Portland, OR


Return to Electronics

Who is online

Users browsing this forum: No registered users and 2 guests

Your purchase from these sites helps support the MIMForum, but only if you start at the links below!!!
Amazon music     Amazon books     Amazon tools     Rockler tools     Office Depot    

The MIMF is a member-supported forum, please consider supporting us with a donation, thanks!
 • Book store • Tool store • Links •