StewMac tools            

neck heel crushing sides of guitar

Please put your pickup/wiring discussions in the Electronics section; and put discussions about repair issues, including fixing errors in new instruments, in the Repairs section.

Re: neck heel crushing sides of guitar

Postby Bob Orr » Thu May 25, 2017 3:53 pm

Glad you got a solution. You need to leave a small space between the end of the tenon and the mortise. If it has been bottoming out them the temptation is to crank on the bolts to try to get the heel to sit flush. Looking at the amount of denting on the bindings at the soundboard I think the bolts have been cranked up way too high. Bob
Bob Orr
 
Posts: 67
Joined: Fri Dec 28, 2012 1:20 pm
Location: Nailsea, Nr Bristol, UK

Re: neck heel crushing sides of guitar

Postby Brian Evans » Fri May 26, 2017 7:53 am

I can safely say some lessons were learned... :) Side note - these furniture bolts were invented by places like Ikea. You know how they always give you that little allen wrench that is a stupid small size? Cleverly engineered so even a ham-fisted man can't actually do a lot of damage over-torquing the bolts - the wrench hurts your fingers first!
Brian Evans
 
Posts: 502
Joined: Sat Aug 30, 2014 8:26 am
Location: Tatamagouche, Nova Scotia

Previous

Return to Archtop Guitars and Bass Guitars

Who is online

Users browsing this forum: No registered users and 2 guests

Your purchase from these sites helps support the MIMForum, but only if you start at the links below!!!
Amazon music     Amazon books     Amazon tools     Rockler tools     Office Depot    

The MIMF is a member-supported forum, please consider supporting us with a donation, thanks!
 • Book store • Tool store • Links • 
cron