Page 1 of 1
radius dish
Posted: Fri Nov 03, 2017 3:33 pm
by Elmin Basovic
do i need a radius dish when I'm making a guitar?
Re: radius dish
Posted: Fri Nov 03, 2017 10:19 pm
by Freeman Keller
It is helpful but not necessary. For my first couple I made some radiused cauls that I used to clamp braces against
You can stick sandpaper to the cauls later to sand the kirfing to the correct angle.
Another trick with a go-bar is to take a stack of buisness cards and fan them out on the bottom plate of the deck - take your curved brace and make the fan fit the brace. Then clamp against the cards