StewMac tools

heel/tail block question?

Please put your pickup/wiring discussions in the Electronics section; and put discussions about repair issues, including fixing errors in new instruments, in the Repairs section.

heel/tail block question?

Postby Jason Brown » Thu May 18, 2017 6:19 pm

Does the gluing face of the heel block need to be flat or can it have a slight curve before gluing to the sides? Same for the tail block?
Jason Brown
 
Posts: 37
Joined: Fri Jan 20, 2012 10:47 pm

Re: heel/tail block question?

Postby Bob Gramann » Thu May 18, 2017 6:33 pm

This answer assumes that you are talking about the surface that glues to the rim--the sides. A couple of my models have a curved face on the gluing surface of the tail block. I use a piece of quarter inch Lexan as a gluing caul since it will conform to the curve when clamped. The heel block can be curved the same way but that makes it harder to fit the neck, so I don't do that.
User avatar
Bob Gramann
 
Posts: 692
Joined: Fri Jan 06, 2012 11:08 am
Location: Fredericksburg, VA

Re: heel/tail block question?

Postby Barry Daniels » Thu May 18, 2017 7:04 pm

If the blocks are flat then the resulting shape of the guitar will have obvious flat places at the top and bottom. The bottom will be more obvious because it is more exposed. I always shape them to fit the curved shape, but then it is easy with my Shopsmith's large disk sander.
MIMF Staff
Barry Daniels
 
Posts: 1722
Joined: Thu Jan 05, 2012 10:58 am
Location: Houston, Texas


Return to Flat-Top Acoustic Guitars and Bass Guitars

Who is online

Users browsing this forum: No registered users and 3 guests

Your purchase from these sites helps support the MIMForum, but only if you start at the links below!!!
Amazon music     Amazon books     Amazon tools     Rockler tools     Office Depot    

The MIMF is a member-supported forum, please consider supporting us with a donation, thanks!
 • Book store • Tool store • Links •