Neck profile on a Guild F50

Please put your pickup/wiring discussions in the Electronics section; and put discussions about repair issues, including fixing errors in new instruments, in the Repairs section.

Neck profile on a Guild F50

Postby Doug Shaker » Thu Apr 27, 2017 3:16 pm

I am making a guitar for a friend and the guitar that he currently uses is a Guild F50R. I'd like to duplicate the neck profile as much as possible, but his guitar is 75 miles North of me. Does anyone know of an on-line resource that might have detailed neck profile measurements?
-Doug Shaker
Doug Shaker
Posts: 274
Joined: Sat Jan 07, 2012 9:21 pm
Location: Palo Alto, California

Re: Neck profile on a Guild F50

Postby Freeman Keller » Thu Apr 27, 2017 9:54 pm

Buy him a contour duplicator and have him take several profiles - nut, 6th fret, 12th. Trace the profiles, scan and e-mail to you. Then have him ship the duplicator to you - I use mine all the time ... 3=&veh=sem

I would also have him take a couple of depth and width measurements with calipers if he has them - same places
Freeman Keller
Posts: 329
Joined: Mon Feb 27, 2012 11:34 am

Return to Flat-Top Acoustic Guitars and Bass Guitars

Who is online

Users browsing this forum: No registered users and 8 guests

Your purchase from these sites helps support the MIMForum, but only if you start at the links below!!!
Amazon music     Amazon books     Amazon tools     Rockler tools     Office Depot    

The MIMF is a member-supported forum, please consider supporting us with a donation, thanks!
 • Book store • Tool store • Links •