Page 2 of 2

Re: Looking at these guitar plans

Posted: Mon May 08, 2017 9:38 pm
by Bob Howell
I am going to get prints of the L-00 plans. Do I take the PDF for printing at Kinkos? DXF file did not download.

Re: Looking at these guitar plans

Posted: Mon May 08, 2017 10:46 pm
by Eric Knapp
Bob Howell wrote:I am going to get prints of the L-00 plans. Do I take the PDF for printing at Kinkos? DXF file did not download.
The places that can print this big should all be able to deal with the PDF just fine. I suspect most places prefer PDF. They are sized to a European paper size but they will work fine on a 36" by 48" printout. I had all three of the guitar plans printed.

-Eric

Re: Looking at these guitar plans

Posted: Wed May 10, 2017 4:14 pm
by Bob Howell
I found out you can open an account online and send it over with payment; then go pick it up. Waiting for the cost, but very simple.

Re: Looking at these guitar plans

Posted: Sat May 13, 2017 3:56 pm
by Bob Howell
I am thinking of building one of the OO models shown here for my next build. They seem very similar with just minor differences in bracing. If I made a mold for my Fox binder couldn't I use it for either.

My daughter printed up the Gibson L-OO at her print shop on clear laminate with adhesive on one side which I will bond to a sheet of acetate.

I am working on three OM models using Cumpino's book as a guide. Look's like I can easily use it, and these plans for the smaller size.