Looking at these guitar plans
-
- Posts: 234
- Joined: Sun Jan 08, 2012 4:23 am
- Location: Atlanta, GA
Re: Looking at these guitar plans
I am going to get prints of the L-00 plans. Do I take the PDF for printing at Kinkos? DXF file did not download.
- Eric Knapp
- Posts: 630
- Joined: Mon May 02, 2016 2:01 pm
- Location: Wisconsin, USA
- Contact:
Re: Looking at these guitar plans
The places that can print this big should all be able to deal with the PDF just fine. I suspect most places prefer PDF. They are sized to a European paper size but they will work fine on a 36" by 48" printout. I had all three of the guitar plans printed.Bob Howell wrote:I am going to get prints of the L-00 plans. Do I take the PDF for printing at Kinkos? DXF file did not download.
-Eric
-
- Posts: 234
- Joined: Sun Jan 08, 2012 4:23 am
- Location: Atlanta, GA
Re: Looking at these guitar plans
I found out you can open an account online and send it over with payment; then go pick it up. Waiting for the cost, but very simple.
-
- Posts: 234
- Joined: Sun Jan 08, 2012 4:23 am
- Location: Atlanta, GA
Re: Looking at these guitar plans
I am thinking of building one of the OO models shown here for my next build. They seem very similar with just minor differences in bracing. If I made a mold for my Fox binder couldn't I use it for either.
My daughter printed up the Gibson L-OO at her print shop on clear laminate with adhesive on one side which I will bond to a sheet of acetate.
I am working on three OM models using Cumpino's book as a guide. Look's like I can easily use it, and these plans for the smaller size.
My daughter printed up the Gibson L-OO at her print shop on clear laminate with adhesive on one side which I will bond to a sheet of acetate.
I am working on three OM models using Cumpino's book as a guide. Look's like I can easily use it, and these plans for the smaller size.