StewMac tools

Fretting, backbow

Please put your pickup/wiring discussions in the Electronics section; and put discussions about repair issues, including fixing errors in new instruments, in the Repairs section.

Re: Fretting, backbow

Postby Stephen Neal Saqui » Wed Dec 07, 2016 11:31 pm

My comments about Stewmac's Fret Barber were addressed to repair, not new building. It's pretty obvious that when building you want to match the frets with the slot width beforehand.
Stephen Neal Saqui
 
Posts: 188
Joined: Fri Jan 30, 2015 10:59 am
Location: Challis, Idaho

Re: Fretting, backbow

Postby Craig Bumgarner » Thu Dec 08, 2016 9:36 am

Fretted a new neck this morning using the tips suggested in this thread. Enlarged my slots a bit with one of many saws I have laying around so the slot was .002" over the tang width, then used the Fret Barber to take the barb width from .036" to .030". Fret went in like butter, formed well and seemed to hold well in spite of going in so much easier. No back bow at all. Glued the frets with thin CA after they were set and they had been gone over several times for few minor high spots. Leveled the frets with ease, very pleased.

Thanks for all your help!
Craig Bumgarner
 
Posts: 357
Joined: Mon Jan 09, 2012 3:03 pm
Location: Drayden, Maryland

Re: Fretting, backbow

Postby Mario Proulx » Sat Dec 10, 2016 2:40 pm

Careful not to make the frets fit too "nicely". Wood moves with seasons, and what might be a nice fit in your shop could end up being too loose if the instrument lives in a dry environment, leading to frets that can pop-up, or at the very least, inconsistent fretted tone...
Mario Proulx
 
Posts: 760
Joined: Fri Jan 06, 2012 12:08 pm

Previous

Return to Flat-Top Acoustic Guitars and Bass Guitars

Who is online

Users browsing this forum: Google [Bot] and 1 guest

Your purchase from these sites helps support the MIMForum, but only if you start at the links below!!!
Amazon music     Amazon books     Amazon tools     Rockler tools     Office Depot    

The MIMF is a member-supported forum, please consider supporting us with a donation, thanks!
 • Book store • Tool store • Links •