StewMac tools

Bending Curly Maple Bindings

Please put your pickup/wiring discussions in the Electronics section; and put discussions about repair issues, including fixing errors in new instruments, in the Repairs section.

Re: Bending Curly Maple Bindings

Postby Greg Marks » Mon Jun 26, 2017 9:28 am

Thanks for all of the tips everybody. I went and got 6 more strips of the curly maple , applied all the things as posted shaved the thickness down on my belt sander to around .080" and finished reducing with the scraper to .070" and they turned out really nice. Very pleased. Also I just realized , after all the ribs have been glued to the blocks, the top block which should sit 3/32" below the top side of the mould is 5/32" , when converting to /32" of an inch I got it wrong . How critical is this difference of 2/32". Or can I just build it up.
thanks.
Greg Marks
 
Posts: 3
Joined: Wed Jun 14, 2017 10:15 pm

Re: Bending Curly Maple Bindings

Postby Barry Daniels » Mon Jun 26, 2017 10:32 am

Just build it up, no biggie.
MIMF Staff
Barry Daniels
 
Posts: 1734
Joined: Thu Jan 05, 2012 10:58 am
Location: Houston, Texas

Previous

Return to Flat-Top Acoustic Guitars and Bass Guitars

Who is online

Users browsing this forum: No registered users and 2 guests

Your purchase from these sites helps support the MIMForum, but only if you start at the links below!!!
Amazon music     Amazon books     Amazon tools     Rockler tools     Office Depot    

The MIMF is a member-supported forum, please consider supporting us with a donation, thanks!
 • Book store • Tool store • Links •