Hello,
I turned this persuader from a bit of ash, and it's proven handy. A friend hefted it, and I mentioned that I read an article that discussed the mechanical properties of a hammer, and the conclusion was that there is an optimal balance point on the handle, where the transfer of power of the swing was maximized for delivery to the target rather than the hand & arm.
Does anybody know the reference?
You could imagine this in a different way. Just imagine that you were the first batter on Opening Day and swatted the baseball...
a question for the mechanical engineer
-
- Posts: 638
- Joined: Sun Jul 22, 2012 4:13 pm
-
- Posts: 2690
- Joined: Sat Jan 07, 2012 10:01 pm
- Location: Portland, OR
- Contact:
Re: a question for the mechanical engineer
I'd be tempted to drill out the head and keep filling it with steel shot until you hit the optimum mass. If you didn't want a "dead-blow" you could encapsulate the shot with epoxy to immobilize it in the head.
Also some flexibility in the shaft may help insulate the operator from shock transmission to the handle and hand.
Also some flexibility in the shaft may help insulate the operator from shock transmission to the handle and hand.
-
- Posts: 640
- Joined: Thu Dec 27, 2012 4:28 pm
Re: a question for the mechanical engineer
or wrap the handle with some grip tape.