Page 1 of 1

Drop-fill question

PostPosted: Thu Oct 05, 2017 11:07 am
by Steve Sawyer
I just finished level-sanding the nitro clearcoats on the body of my first build, and have revealed a few spots that need to be drop-filled.

Am I correct that I will need to allow these fills to COMPLETELY cure before scraping or sanding them flush?

Thanks.

Re: Drop-fill question

PostPosted: Thu Oct 05, 2017 12:17 pm
by Barry Daniels
If you have time, let them cure for a couple of weeks at a minimum. Otherwise you will have some shrinkage which will show in the finish.

Re: Drop-fill question

PostPosted: Thu Oct 05, 2017 9:08 pm
by Steve Sawyer
Barry Daniels wrote:Otherwise you will have some shrinkage which will show in the finish.


That's what I was thinking.

Thanks, Barry.