StewMac tools

shatten thumb wheel bare ground wire question

Pickups, magnets, microphones, amps, speakers, cabs, whatever...

shatten thumb wheel bare ground wire question

Postby Greg Martin » Mon Jun 08, 2015 8:20 pm

hi Im using the shatten t2 thumbwheel controls and a production Armstrong floating pickup on this arch top build and need clarification on the bare ground wire placement.
The wire in the kit is 2 lead no bare wire unshielded. I want to use a shielded 2 lead with bare wire .will the bare wire twist with the neg pickup wire to the control tab, as well as the neg of the jack ? or do you leave one end of the bare un soldered and only solder the neg wire to the ground tab of the jack . There is no mention of shielded wiring or ground wire from Armstrong and I just plain forget ???
Greg Martin
 
Posts: 290
Joined: Thu Feb 23, 2012 7:18 pm

Return to Electronics

Who is online

Users browsing this forum: No registered users and 1 guest

Your purchase from these sites helps support the MIMForum, but only if you start at the links below!!!
Amazon music     Amazon books     Amazon tools     Rockler tools     Office Depot    

The MIMF is a member-supported forum, please consider supporting us with a donation, thanks!
 • Book store • Tool store • Links •